Saras & Associates  Precision Manufacturing                                                           
Custom Parts Manufactured to Your Specifications


Featured Process

CNC Lathe

What is Machining?

Machining is cutting and forming of metal or plastic  by.....


Read More



                                          Springs: Compression, Extension & Torsion


A spring is defined in its most simplest form as an elastic device used to store energy. Springs are usually made from coiled, spring steel wire. There are a large number of spring designs, broken down into three primary catagories;

- Compression
- Extension
- Torsion 

There are also "constant force springs" such as those found in a tape measure. Springs can be made out of round, flat or square wire. Small springs can be wound from "pre-hardened" stock while larger springs are made from "annealed steel wire" and hardened after fabrication. Some non-ferrous metals are also used, including phosphor bronze and titanium, for parts requiring corrosion resistance and beryllium copper for springs carrying electrical current (because of its low electrical reisitance).

When a coil spring is compressed or stretched slightly from rest, the force it exerts is approximately proportional to its change in length. The "Rate" of a spring is the change in the force it exerts, divided by the change in its deflection. A compression or extension spring has "Units of Force" divided by distance. A torsion spring has "Units of Torque" divided by angle and degree. The inverse of Spring Rate is Compliance.

Depending on the design and required operating environment, any material can be used to construct a spring, so long as the material has the required combination of rigidity and elasticity.

                                                                       PHONE  (916) 202-1104    TOLL FREE FAX  (866) 265-0011   EMAIL: INFO@SARASINC.COM